ProCurve 420 Bedienungsanleitung PDF herunterladen (Seite 31)

Software Fixes

Release 2.0.38

Problems Resolved in Release 2.0.38

■ Management — The AP 420 with 2.0.38 software can now be managed by AirWave Manage-

ment Platform (AMP) 3.0.6 and above.

■ CLI/Web — When using the CLI to reboot the access point, the reset board command does

not work if the command is typed using upper case characters, such as “reset Board,” or

“RESET BOARD.” (18-00120, 18-00381)

■ CLI/Web — In the Web interface, an error message is not displayed when invalid characters

are entered in the Native VLAN ID text field. (18-00158)

■ CLI/Web — In the Web interface, the error message for the SNTP Server configuration for

minutes incorrectly shows “Month.” (18-00162)

■ CLI/Web — In the CLI there is no enable/disable status displayed for the show interface

ethernet command. (18-00194)

■ CLI/Web — In the Web interface Port/Radio Settings page, when the radio is set to “g only”

mode, the Maximum Station Data Rate can still be set to 1, 2, 5.5, 11 Mbps. (18-00215)

■ CLI/Web — Using the CLI interface the Radius server name must be specified as an IP

address and not a host name string. The Web interface does not have this problem. (18-00226)

■ CLI/Web — Using the CLI interface, the sntp-server daylight-saving command accepts values

for day and month that are a mixture of integer numbers and alphabetic letters. (18-00227)

■ CLI/Web — Using the CLI interface, invalid IP addresses can be entered for an SNTP server

IP (primary or secondary). (18-00228, 18-00273)

■ CLI/Web — Using the CLI interface, no error message is displayed when invalid IP addresses

are entered for a DNS server IP (primary or secondary), even though the new value is not

set. (18-00230, 18-00275)

■ CLI/Web — The CLI interface does not accept a WPA Pre-Shared Key value with space

characters. (18-00251, 18-00287)

■ CLI/Web — The snmp-server host command in the CLI interface accepts invalid IP addresses

and if the SNMP community is specified using more than 23 characters, this overwrites the

host IP address. (18-00256)

■ CLI/Web — In the CLI interface the show interface ethernet command always displays the

Admin Status of the Ethernet interface as “Up,” even when the interface has been shutdown.

(18-00257)

■ CLI/Web — The CLI command transmit-power does not accept any setting using upper case

letters (for example, “FULL” instead of “full”). (18-00267)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Keine Kommentare

ProCurve 420 Bedienungsanleitung Seite 31