ProCurve 420 Bedienungsanleitung PDF herunterladen (Seite 19)

New Features

Pure 802.11g Mode

Software release 2.1.2 supports a proprietary “pure 11g only” radio working mode for enhanced

wireless performance. In this mode the access point only supports 802.11g clients at OFDM data rates

without the use of the 802.11 “protection” mechanism that is employed when 802.11b devices are

detected in the service area.

The following four four radio working modes are supported:

■ b & g mixed mode: Both 802.11b and 802.11g clients can communicate with the access

point. Supports unicast data rates of 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps, and multicast

data rates of 1, 2, 5.5, and 11 Mbps.

■ b only mode: Both 802.11b and 802.11g clients can communicate with the access point, but

802.11g clients can only transfer data at 802.11b standard rates (up to 11 Mbps). Supports

unicast data rates of 1, 2, 5.5, 11 Mbps, and multicast data rates of 1, 2, 5.5, and 11 Mbps.

■ g only mode: Only 802.11g clients can communicate with the access point. Supports unicast

data rates of 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps, and multicast data rates of 6, 12,

and 24 Mbps.

■ pure g only mode: Only 802.11g clients can communicate with the access point. Supports

unicast data rates of 6, 9, 12, 18, 24, 36, 48, 54 Mbps, and multicast data rates of 6, 12, and

24 Mbps.

Syntax: radio-mode <b | b+g | g | pure11g>

For example, to set the radio working mode to “pure 11g only”:

HP420(if-wireless-g)#radio-mode pure11g

To display the current radio working mode setting, use the show command from the wireless interface

level or the show interface wireless g command from the Exec level.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Keine Kommentare

ProCurve 420 Bedienungsanleitung Seite 19