ProCurve 2510G Series Technical Information PDF herunterladen (Seite 220)

100

101

11-14

Port Trunking

Port Status and Configuration

The following examples show how to create different types of trunk groups.

Configuring a Static Trunk or Static LACP Trunk Group.

For switches covered in this guide:

Syntax: trunk <port-list> < trk1 ... trk24 > < trunk | lacp >

The following example uses ports 4 - 6 to create a non-protocol static trunk

group with the group name of Trk2.

ProCurve(config)# trunk 4-6 trk2 trunk

Removing Ports from a Static Trunk Group. This command removes

one or more ports from an existing Trkx trunk group.

Caution Removing a port from a trunk can result in a loop and cause a broadcast storm.

When you remove a port from a trunk where STP is not in use, ProCurve

recommends that you first disable the port or disconnect the link on that port.

Syntax: no trunk < port-list >

This example removes ports 4 and 5 from an existing trunk group.

ProCurve(config)# no trunk 4-5

Enabling a Dynamic LACP Trunk Group. In the default port configura-

tion, all ports on the switch are set to LACP Passive. However, to enable the

switch to automatically form a trunk group that is dynamic on both ends of

the link, the ports on one end of a set of links must be LACP Active. The ports

on the other end can be either LACP Active or LACP Passive. This command

enables the switch to automatically establish a dynamic LACP trunk group

when the device ports on the other end of the link are configured for LACP

Passive.

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 411 412

Kommentare zu diesen Handbüchern

Keine Kommentare

ProCurve 2510G Series Technical Information Seite 220

Kommentare zu diesen Handbüchern