ProCurve 2510G Series Technical Information PDF herunterladen (Seite 171)

100

101

9-19

Time Protocols

TimeP: Viewing, Selecting, and Configuring

The commands and output would appear as follows:

Figure 9-12. Example of Enabling TimeP Operation in DHCP Mode

Enabling Timep in Manual Mode. Like DHCP mode, configuring TimeP

for Manual mode enables TimeP. However, for manual operation, you must

also specify the IP address of the TimeP server. (The switch allows only one

TimeP server.) To enable the TimeP protocol:

Syntax: timesync timep

Selects Timep.

ip timep manual <ip-addr>

Activates TimeP in Manual mode with a specified TimeP

server.

no ip timep

Disables TimeP.

Note To change from one TimeP server to another, you must (1) use the no ip timep

command to disable TimeP mode, and then reconfigure TimeP in Manual

mode with the new server IP address.

For example, to select TimeP and configure it for manual operation using a

TimeP server address of 10.28.227.141 and the default poll interval (720

minutes, assuming the TimeP poll interval is already set to the default):

ProCurve(config)# timesync timep

Selects TimeP.

ProCurve(config)# ip timep manual 10.28.227.141

Activates TimeP in Manual mode.

show timep displays the TimeP configuration and also shows

that SNTP is the currently active time synchronization mode.

show timep again displays the TimeP configuration and shows that TimeP is

now the currently active time synchronization mode.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 411 412

Kommentare zu diesen Handbüchern

Keine Kommentare

ProCurve 2510G Series Technical Information Seite 171

Kommentare zu diesen Handbüchern